Air Pressures; Explosion Hazard; Special Rim/Tyre Considerations; Intended Use Of The Machine - Mondolfo Ferro AS 914 TI Manuel D'utilisation

1.2.e. AIR PREssUREs
The machine is equipped with an internal pressure limiting valve to minimize the risk
of over inflating the tyre.
1. Never exceed these pressure limitations:
• Supply line pressure (from compressor) is 220 psi (15 bar).
• Operating pressure (gauge on regulator) is 145 psi (10 bar).
Bead setting pressure (gauge on hose) is the tyre manufacturer's maximum pressure as
stated on the sidewall of the tyre
2. Activate air inflation jets only when sealing the bead.
3. Bleed air pressure system before disconnecting supply line or other pneumatic com-
ponents. Air is stored in a reservoir for operation of inflation jets.
4. Only activate the air inflation jets if the rim securing device is locked in place and the
tyre is properly clamped (when possible).

1.3. sPECIAL RIM/TYRE CONsIDERATIONs

Wheels equipped with low tyre pressure sensors or special tyre and rim designs may require
special procedures. Consult wheels and tyre manufacturers' service manuals.

1.4. INTENDED UsE OF ThE MAChINE

This machine must be used only to remove and replace an automotive tyre on an auto-
motive rim, using the tools with which it is equipped. Any other use is improper and can
result in an accident.
The machine can not work on motorcycle wheels.

1.5. EMPLOYEE TRAININg

1. The employer is obligated to provide a programme to train all employees who service
rim wheels in the hazards involved in servicing those rim wheels and the safety procedures
to be followed. Service or servicing means the mounting and demounting of rim wheels,
and related activities such as inflating, deflating, installing, removing and handling.
AS 914 TI User Manual
DANGER

• EXPLOSION HAZARD

• Never exceed the tyre pressure recommended by the tyre
manufacturer. Never mismatch tyre size and rim size.
• Avoid personal injury or death
NOTICE
17