Maintenance; Care And Cleaning; Environmental Protection - Evolution RAGE3-S Instructions D'origine

www.evolutionpowertools.com

MAiNTENANCE

Note: Any maintenance must be carried out with
the machine switched off and disconnected from
the mains/battery power supply.
Check that all safety features and guards are
operating correctly on a regular basis. Only use
this machine if all guards/safety features are
fully operational.
All motor bearings in this machine are lubricated
for life. No further lubrication is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNiNG: Do not attempt to clean by inserting
pointed objects through openings in the
machines casings etc. The machines air vents
should be cleaned using compressed dry air.
Excessive sparking may indicate the presence
of dirt in the motor or worn out carbon brushes
located in the motor housing. If this is suspected,
have the carbon brushes replaced.
TABLE iNSERT
A two piece table insert is fitted to this
machine. If either side is damaged or worn,
both parts must be replaced. Replacement
inserts (sold in handed pairs) are available
from your supplier or Evolution Power Tools.
To replace the table inserts:
• Remove the 3 or 4 cross-head screws that
secure one of the inserts to the rotary table.
• Lift the insert from the table.
• Remove any debris that may have
accumulated under the insert.
• Fit the replacement insert, and replace the
three fixing screws.
• Repeat the process for the other side.
• Check that all 6 or 8 fixing screws are tightened
securely, and that both inserts are lying flush
and level within the table.
(6.4)

ENViRONMENTAL pROTECTiON

information (for private
householders) for the
environmentally responsible
disposal of Waste Electrical and
Electronic Equipment (WEEE).
This symbol on products, or accompanying
documents, indicates that used and end of life
electrical and electronic equipment should not
be disposed of with household waste. For proper
disposal, treatment, recovery and recycling,
please take these products to designated
collection points, where they will be accepted
on a free of charge basis Alternatively, in some
countries you may be able to return your
products to your retailer upon the purchase of
an equivalent new product. Disposing of this
product correctly will help to save valuable
resources and prevent any potential adverse
effects on human health and the environment,
which could otherwise arise from inappropriate
waste disposal and handling. Please contact your
local authority for further details of your nearest
designated collection point. Penalties may be
applicable for incorrect disposal of this waste in
accordance with national legislation.
FOR BUSiNESS USERS iN
ThE EUROpEAN UNiON
If you wish to discard electrical and electronic
equipment, please contact your dealer or
supplier for further information.
information on Disposal in other Countries
outside the European Union
This symbol is only valid in the European
Union. If you wish to dispose of this product,
please contact your local authorities or dealer
and ask for the correct method of disposal.
37