Safety Labels & Symbols - Evolution RAGE3-S Instructions D'origine

www.evolutionpowertools.com
the operator could develop "Vibration white finger
disease" (Raynaud syndrome). This condition can
reduce the sensitivity of the hand to temperature
as well as producing general numbness.
Prolonged or regular users of mitre saws should
monitor the condition of their hands and fingers
closely. If any of the symptoms become evident,
seek immediate medical advice.
a. The actual vibration level during use
will depend on the workpiece stability/
rigidity and the condition of the cutter
being used. These factors may increase the
vibration experienced by the operator. Each
individual application of the tool should be
assessed for the effect of these application
variable factors, before exposure.
b. The measurement and assessment of
human exposure to hand-transmitted
vibration in the workplace is given in:
BS EN iSO 5349-1:2001 and
BS EN iSO 5349-2:2002
c) The following factors can influence the
level of vibration. Reducing these factors will
help to reduce the effects of vibration:
handling:
• Handle the machine with care, allowing
the machine to do the work.
• Avoid using excessive physical effort on
any of the machines controls.
• Consider your security and stability, and
the orientation of the machine during use.
Workpiece:
• Consider the work surface material;
its condition, density, strength,
rigidity and orientation.
WARNiNG: The vibration emission during actual
use of the power tool can differ from the declared
total value depending on the ways in which the
tool is used. The need to identify safety measures
and to protect the operator are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle, such as the times the tool is switched off,
when it is running idle, in addition to trigger time).
(1.8)
SAFETY LABELS & SYMBOLS
WARNiNG: Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools
for replacement labels.
Note: All or some of the following symbols
may appear in the manual or on the product.
Symbol Description
V
A
Amperes
Hz
Hertz
min (RPM)
-1
Speed
~
Alternating Current
n
No Load Speed
o
Wear Safety Goggles
Wear Ear Protection
Do Not Touch,
Keep hands away
Wear Dust Protection
Wear Hand Protection
CE certification
Waste electrical and
electronic equipment
Read Manual
WARNING
Laser Warning
Double Insulation Protection
Lifting / Transporting Hand Position
(RCM) Regulatory Compliance Mark
for electrical and electronic equipment.
Australian/New Zealand Standard
7
Volts