Maintenance; Environmental Protection - Evolution STEALTH 3-B Instructions Originales

www.evolutionpowertools.com
Note: For operational efficiency empty
the Dust Bag when it becomes 2/3 full.
Dispose of the contents of the Dust Bag in an
environmentally responsible way. It may be
necessary to wear a dust mask when
emptying the Dust Bag.
Note: A workshop vacuum extraction machine
can be attached to the dust extraction
port if required. Follow the manufacturers
instructions if such a machine is fitted.
WARNING: Do not use the Dust
Bag when cutting metallic materials.
(6.1)

MAINTENANCE

Note: Any maintenance must be carried
out with the machine switched off and
disconnected from the mains/battery
power supply.
Check that all safety features and guards
operating correctly on a regular basis.
Only use this machine if all guards/safety
features are fully operational.
All motor bearings in this machine are
lubricated for life. No further lubrication
is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by
inserting pointed objects through openings
in the machines casings etc. The machines air
vents should be cleaned using compressed
dry air. Excessive sparking may indicate the
presence of dirt in the motor or worn out
carbon brushes.
(6.2) If this is suspected have the machine
serviced and the brushes replaced by
a qualified technician.
Table Insert
A one piece table insert is fitted to this
machine. If it is damaged or worn, it must be
replaced. Replacement inserts are available
from Evolution Power Tools.
To replace the table inserts:
• Remove the cross-head screw that secures
the insert to the rotary table.
Note: It may be necessary to temporarily
remove or reposition the fence to gain access
to the fixing screw.
• Lift the insert from the table.
• Remove any debris that may have
accumulated under the insert.
• Fit the replacement insert, and replace the
fixing screw.
• If necessary replace and re-align the fence.
(see Fence Alignment and Figs 12 & 13)
• Check that the insert is lying flush and level
within the table.
(6.4)

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
27
EN
DE
FR
IT
NL