Laser Safety - Evolution RAGE3-S Instructions D'origine

www.evolutionpowertools.com
Note: The above adjustments & alignments should be checked
on a regular basis to ensure laser accuracy.
Note: The following WARNING labels
may be found on this machine:
LASER RADiATiON
DO NOT STARE iNTO ThE BEAM
CLASS 2 LASER pRODUCT

LASER SAFETY

The Laser guide line used in this product uses a class 2 Laser with a
maximum power output of 1mW at a wave length of between 635
and 670nm. These lasers do not normally present an optical hazard,
although staring at the beam may cause temporary flash blindness.
WARNiNG: Do not stare directly at the Laser beam. The laser
must be used and maintained as detailed in this manual. Never
intentionally aim the laser beam at any person and prevent it
from being directed towards the eye, or an object other than the
workpiece. Always ensure that the laser beam is directed at the
workpiece only when it is located on the mitre saw table.
Never direct the laser beam onto any bright, shiny reflective
surface, as the laser beam could be reflected back towards the
operator. Do not change the laser unit for any other type.
Do not tamper with the laser unit. Only touch the unit when
making adjustments. Repairs to the laser shall only be carried
out by an authorised service centre.
The laser guide line
The projected laser guide line shows the path of the blade
during a cut.
To use the laser guide for a known angle (e.g. 45
• Mark the cut required on the workpiece using a pencil etc.
• Set the saw to the cutting angle required (45
position using the mitre locking handle and/or the positive
stop locking lever.
• Switch on the laser beam.
• Position the workpiece on the rotary table and against the fence.
• Slide the workpiece into position until the pencil line on the
workpiece and the projected laser line exactly match.
• Clamp the workpiece into position using the hold down clamp.
• Proceed to make the cut.
):
0
) and lock into
0
19