SCHUBERTH J1 Manuel page 46

H. M INTEN NCE ND C RE
Note:
Always avoid temperatures above 40 °C and high humidity in the
place where the visor is stored, as these can cause damage to
the visor.
3. INTERIOR LINING
Replaceable parts of the interior lining
The head pads and head strap can be removed for handwashing with
commercially available mild detergent (ideally in a low concentration
diluted in water) at max. 30° C. Leave to dry at room temperature in a
well ventilated room.
Tip:
If required (e.g. during a break in a journey), the headband can
be hung out to dry over the mirror.
N on- r epl aceabl e part s oft he i nt eri or l i ni ng
Use a mild, lukewarm soap solution (e.g. any very diluted, normal mild
detergent can be used) to clean the interior lining.
Carefully apply the soap solution with a damp sponge or cloth by
dabbing or gentle rubbing. The inner padding should not be soaked
with water. Remove the soap solution from the padding by pressing a
dry, absorbent cloth on it. Repeat this process with clear water.
Afterwards, allow the interior padding to dry in a well-ventilated place.
TechSkin
It is best to clean the TechSkin comfort material (with high-quality,
leather-like surface structure) regularly with a soft, moistened cloth.
92
4. CHIN GUARD HOOP
For the cleaning and care of the chin guard hoop, use water and a mild
soapy solution.
Note:
Never use motor fuel, thinners or solvents or other aggressive
substances to clean the chin guard hoop. These substances can
cause serious damage with no externally visible indication. The
full safety function of the helmet is then no longer guaranteed.
Caution:
Do not oil or grease the chin guard hoop and locking system.
5. FASTENER SYSTEM
Push-button quick-release fastener
The metal parts of the fastener system can, if required, be lightly
lubricated with colourless, acid-free grease. To do this, use a thin cloth
or similar (e.g. sponge or small brush). Apply the grease sparingly.
6. STORING THE HELMET
When not in use, keep the helmet in the supplied helmet bag in a dry,
safe place. For better ventilation and protection of the anti-fog coating,
make sure the visor is not fully closed, but is locked in at least the
second locking position above the town-riding position. Always store
the helmet so that there is no risk of it falling onto the floor. Damage
caused this way is not covered by the guarantee.
Note:
Store the helmet out of reach of children and animals.
93