SCHUBERTH J1 Manuel page 35

D. THE HELMET
REPLACING THE VISOR SHIELD
With the new EasyChange visor mechanism, the visor shield is easy to
replace without tools. To replace the visor, it is helpful to place the
helmet on a flat surface or on your thighs while seated.
Rem ovi ng t he vi sor shi el d
1. Open the visor completely without forcing
it; this allows access to the actuator lever
for the visor holder.
2. With the thumb, move the operating lever
in the direction of the arrow.
3. The T-pegs of the visor are released and
the visor then springs out of its holder.
4. Repeat the above steps for the other side
of the visor.
Fitting a new visor shield
1. Insert the pivot peg of the visor into the
recess provided for it in the visor
mechanism and position the T-peg directly
below the locking elbow.
locking elbow
70
2. By applying light pressure to the visor
both upwards and towards the helmet, the
locking elbow will slide upwards and you
should hear the T-peg of the visor click
into place.
3. Repeat the above steps for the other side
of the visor.
4. Close the visor and check that the locking
mechanism is working properly.
Tip:
A short visor (known from the S1) can be fitted on the J1 as well.
This is suitable for town riding and allows greater air circulation in
the region of the face.
11. SUN VISOR
Shield
The sun visor shield has a grey tint and is heat formed in 3 dimensions.
Due to the visor thickness of 1.5 mm, the sun visor still gives
T-peg
protection from light impact from stones and insects when the main
visor is pivoted up. In addition, the UV-absorbing properties of the
special polycarbonate mean that the sun visor provides effective
protection against UV radiation.
Coating
The shield is scratch-resistant on both sides and has HighClear
fog coating.
pivot peg
®
anti-
71