SCHUBERTH J1 Manuel page 39

D. THE HELMET
conditions, in cool conditions you may wish to reduce the volume of, or
divert the cold incoming air by partially or fully covering the ventilation
ducts with the two outer head pads.
Vent i l at i on devi ce 3 – i nt eri or ai r r em oval
To guarantee maximum through-ventilation of the
helmet on hot summer journeys, the J1 is
additionally equipped with a multiple air removal
system. Air flowing in through the head vent is
carried out of the helmet firstly via the air outlet
ducts in the inner shell then through the two
large air outlets on top of the helmet, and
secondly at the back via the special netting
material inserted in the neck pad. The reduced
pressure behind the air outlets – even when the
air intake cap is closed – ensures the removal of
interior air, thus guaranteeing a pleasant climate
inside the helmet.
14. ADDITIONAL SAFETY FEATURES
Anti-Roll-Off System (A.R.O.S.)
The Anti-Roll-Off System specially developed by SCHUBERTH and
provided as a safety feature in every SCHUBERTH motorcycle helmet,
ensures – provided the chinstrap is closed and correctly adjusted –
that
a) the helmet cannot pivot off the head from behind
78
b) due to the small angle of tilt, the risk of
contact between the chin section of the
helmet and the chin or neck of the rider
is minimised and
c) the consequences of the helmet
contacting the chest cavity as the result
of an accident are reduced.
b) and c) only apply when the optional chin guard hoop is used
Reflect i ve surf aces
The two large reflective safety panels to the left and right below the
visor also contribute to the characteristic design of the J1. Together
with the silver reflective material on the back of the neck pad, this
makes the rider more noticeable on the road – especially when visibility
is poor. The SCHUBERTH logos on the front and back of single-colour
helmets (without graphics) are also made of reflective foil.
Reflective foil
Reflective eyes
Note:
Keep the safety reflective areas clean.
Note:
When riding in France, local law requires that further reflective
safety stickers be attached at front and back as well as on both
sides of the helmet.
Reflective foil
Reflective padding
79