Faema Faemina Utilisation Et Installation page 66

By autonomy is meant the time for which the softener remains
efficient.
The autonomy is in relation to the water hardness of the place and
the consumption of the use appliance.
To establish what autonomy/capacity to set (through app or machine
sw) it is necessary to establish a priori the hardness of the water
to be used.
This is done using the specific tester strips supplied (n° 2).
Immersing the tester strip in the water one of the following colours,
which correspond to different autonomies, will be seen:
To replace the filter-softener it is necessary to proceed as follows:
1
Remove the basin and the water tank, open the tank.
3
Rinse the new filter with
running water.
5
Reposition the water tank and the basin.
Check that the tank is still correctly engaged.
USE EXCLUSIVELY DRINKING WATER
NOTE: Water, by its nature, contains different concentrations of mineral salts that determine its hardness and
that over time lead to the formation of limescale.
Replacing the water softener filter at the scheduled expiry dates is fundamental for the quality of the
beverages dispensed and for keeping the machine performing correctly.
22
Place it in a container with
a litre of water for at least 5
minutes.
A
orange/
yellow/green
yellow
= 160 L
2
Extract the filter.
4
Position the filter in the specific seat inside the tank.
6
After replacing the water-softener filter dispense hot water
repeatedly until at least ½ litre has been drawn out (for
drawing modes consult the paragraph "Dispensing hot
water").
B C
green
= 120 L = 80 L