General Precautions - Homelite CSP-3314 Manuel D'utilisation

Homelite all in one.qxp
GB
F D E I
GENERAL SAFETY RULES
6. Follow the manufacturer 's sharpening and
maintenance instructions for the saw chain.
7. Use only replacement bars and chains specified by
the manufacturer or the equivalent.
DO NOT OPERATE A CHAINSAW WITH ONE
■
HAND. Serious injury to the operator, helpers, and/or
bystanders may result from one-handed operation.
A chainsaw is intended for two-handed use.
DO NOT OPERATE A CHAINSAW WHEN YOU ARE
■
FATIGUED. Never operate a chainsaw when you are
tired or under the influence of medication, drugs,
or alcohol.
USE SAFETY FOOTWEAR. Wear snug-fitting
■
clothing, protective gloves, and eye, hearing, and
head protection devices.
DO NOT STAND ON ANY UNSTABLE SURFACE
■
while using your chainsaw: that includes ladders,
scaffolds, trees, etc.
USE CAUTION WHEN HANDLING FUEL. Move the
■
chainsaw at least 50 feet (15 m) from the refuelling
point before starting the engine.
DO NOT ALLOW OTHER PERSONS to be near the
■
chainsaw when starting or cutting with the chainsaw.
Keep bystanders and animals out of the work area.
DO NOT START CUTTING until you have a clear
■
work area, secure footing, and a planned retreat path
from the falling tree.
KEEP ALL PARTS OF YOUR BODY away from the
■
saw chain when the engine is running.
ALWAYS CARRY THE CHAINSAW WITH THE
■
ENGINE STOPPED AND THE BRAKE ENGAGED,
the guide bar and saw chain to the rear, and the
silencer away from your body. When transporting the
chainsaw, use the appropriate guide bar scabbard.
DO NOT OPERATE A CHAINSAW THAT IS
■
DAMAGED, improperly adjusted, or not completely and
securely assembled. Be sure that the saw chain stops
moving when the throttle control trigger is released.
TURN OFF THE ENGINE before putting the
■
chainsaw down. DO NOT leave the engine running
unattended. As an additional safety precaution,
apply the chain brake before putting down the saw.
USE EXTREME CAUTION when cutting small-size
■
brush and saplings because slender material may
catch the saw chain and be whipped toward you or
pull you off balance.
WHEN CUTTING A LIMB UNDER TENSION,
■
be alert for spring-back so that you will not be struck
when the tension in the wood fibres is released.
23/12/05 16:14
P NL S DK N FIN GR HU
English
Page 20
CZ RU RO PL SLO HR TR EST LT
KEEP THE HANDLES dry, clean, and free of oil or
■
fuel mixture.
OPERATE THE CHAINSAW ONLY in well-ventilated
■
areas.
DO NOT OPERATE A CHAINSAW IN A TREE
■
unless you have been specifically trained to do so.
ALL CHAINSAW SERVICE, other than the items
■
listed in the instruction manual and all maintenance,
should be performed by competent chainsaw service
personnel. (For example, if improper tools are used to
remove the flywheel or if an improper tool is used to
hold the flywheel in order to remove the clutch,
structural damage to the flywheel could occur and
subsequently cause the flywheel to burst.)
FOLLOW THE SHARPENING and maintenance
■
instructions for the saw chain.
USE ONLY THE REPLACEMENT GUIDE BARS and
■
low kick-back chains specified for your saw.
DO NOT adapt your powerhead to a bow guide or
■
use it to power any attachments or devices not listed
for your saw.
SAVE THESE INSTRUCTIONS. Refer to them
■
frequently and use to instruct other users. If you lend
someone this tool, lend them these instructions also.
SPECIFIC SAFETY RULES
WARNING
The warnings, labels, and instructions found in
this section of the operator's manual are for
your safety. Failure to follow all instructions may
result in serious personal injury.

GENERAL PRECAUTIONS

DO NOT CUT VINES and/or small undergrowth
■
(less than 76 mm (3 in.) in diameter).
SILENCER SURFACES ARE VERY HOT during and
■
after operation of the chainsaw; keep all body parts
away from the silencer. Serious burns may occur if
contact is made with the silencer.
ALWAYS HOLD THE CHAINSAW WITH BOTH
■
HANDS when the engine is running. Use a firm grip with
thumbs and fingers encircling the chainsaw handles.
NEVER LET ANYONE USE YOUR CHAINSAW who
■
has not received adequate instructions in its proper use.
This applies to rentals as well as privately owned saws.
BEFORE YOU START THE ENGINE, make sure the
■
saw chain is not contacting any object.
OPERATE THE CHAINSAW only in well ventilated
■
areas.
20
LV SK BG