BORETTI CRG916 Notice D'utilisation page 64

To re-fit proceed in the inverse direction. Set the lower part of the frame on the
respective pins and press the upper part against the oven wall until it hooks
onto the pin.
10.3 Removing the oven door
The inside fan of the ventilated oven may require periodic cleaning. To
disassemble the fan proceed as follows:
* Make sure that the power supply to the appliance is switched off.
* Remove all inside components (dripping pan, shelves).
* Loosen and remove the four screws A from the cover panel.
* Remove the cover panel B.
* Use a coin to loosen the fixing nut C of the fan (this threading is inverse;
to loosen turn clockwise).
* Remove the fan D and wash it by immersing it in warm water and dish
detergent. Never use abrasive or corrosive detergents, powdered products,
or metal scrubbers. Rinse the fan and dry it thoroughly.
Re-fit the fan and the cover by working in the inverse direction to the
instructions for removal.
64