BORETTI CRG916 Notice D'utilisation page 47

FAULT
The hob or the cooking zones
do not switch on.
The display shows
the adjacent symbol.
The display shows the
adjacent symbol.
The display shows the
adjacent code alternated
with numbers or letters.
The hob or a cooking
zone switches off.
The cooling fan stays on after
the hob is switched off.
CAUSE
The appliance is not correctly
connected to the mains.
The hob lock function has been
activated.
There is no pan on the cooking
zone.
The pan is not suitable for
magnetic induction cooking.
The diameter of the base of the
pan is too small for the cooking
zone.
The knob is not positioned
correctly.
The safety device has triggered.
The device triggers when a
cooking zone is left on by
mistake.
An empty pan has overheated.
This is not a fault.
47
REMEDY
Reconnect the appliance
to the mains.
Deactivate the lock by
following the instructions
in section 6.9
Correctly position a suitable
pan by following the
instructions in section 6.5
Replace the pan with a
suitable one, as indicated
in section 6.5
Replace the pan with a
suitable one, as indicated
in section 6.5
It is not necessary to call
Customer Service; to
restore the radiant element,
simply return the knob to
position "0" and reset the
required power value.
Contact Customer Service
and give the code shown
on the display.
Return the relative knob
to "off" position.
Remove the empty pan
from the cooking zone.
The fan stays on until the
hob has cooled down.
The fan will switch off
automatically.