BORETTI CRG916 Notice D'utilisation page 63

The inner glass can be removed for more thorough cleaning. Proceed as
follows:
* loosen screw C by half a turn to
enable the catch to be lifted from
right to left;
* lift the two catches and slide out
the inner glass;
* to refit the glass, follow the
above instructions in reverse
order.
To clean the area between the outer glass and the intermediate glass, use a
soft brush in the space between the glass panels, as shown on page 62. To
refit the door, follow the instructions on page 62 in reverse order. When the
hinges B are back in their seats, open the door all the way and re-fit the safety
catches of the hinges, lowering the respective pins A (one for each hinge).
Warning:
After re-fitting the door, always be sure to re-fit the hinge safety catches.
10.2 Removing the oven door
The rack-holder frames can be removed to clean them separately and to
facilitate cleaning the oven walls. The frames are hooked to the oven wall in the
three points indicated by the arrows in the figure (detail 1).
* Press downward with your fingers as shown in detail 2 of the figure to
release the frame from the upper pin.
* Lift the frame upward and take it out.
63