5.1.1 One-touch lighting
The hob burners are equipped with a "one-touch" lighting system. To switch
on one of the burners, press the knob corresponding to the required burner
and turn it anticlockwise to the low setting. Hold down the knob to activate
the automatic "one-touch" lighting system. When the burner is on, hold down
the knob for approximately 10 seconds, to allow the safety valve to open. In
the event of a power cut, the burner can also be lit with a match (see section
"5.1.2 Manual lighting"). Should the burner switch off accidentally, the safety
thermocouple blocks the gas flow, even when the tap is open.
Caution:
The device should not been activated for longer than 15 seconds. If after
that time it fails to operate stop pressing the knob, open the window and
wait 1 minute before trying again. In case the flame goes out accidentally
turn off the knob and do not try to switch on the burner for at least 1 minute.
5.1.2 Manual lighting
To light one of the burners, move a lit match towards the burner, press the
corresponding knob and turn it anticlockwise to the minimum setting
Release the knob.
5.2 Switching off the burners
At the end of the cooking, return the knob to position
.
35
.