Particular Safety Instructions; General Warnings; Staff; Transport And Movement - LEGRAND KEOR XPE Serie Manuel De Fonctionnement

2.3

PARTICULAR SAFETY INSTRUCTIONS

2.3.1 General warnings

The UPS is equipped with a series of adhesive plates with instructions on specific hazards;
these plates must always be clearly visible and replaced in the event of damage.
This documentation must always be available near the device; if lost, you are advised to request
a copy from the manufacturer, whose details are available in the "Contacts" section.

2.3.2 STAFF

All work on the UPS must be carried out by qualified staff.
Qualified and trained staff is intended as expert assembly, mounting, start-up and control
people for correct operation of the product, who have the requirements to perform their tasks
and who have read and fully understood this manual, in particular the part relevant to safety.
This training and qualification should only be considered such if certified by the manufacturer.

2.3.3 Transport and movement

During transport and movement of the product, pay utmost attention to avoid bending or
deforming components and changing the insulation distances.
Weight not distributed
The weight of the UPS is not evenly distributed. Pay particular attention when lifting.
Please inspect the device before proceeding to installation. If from the packaging conditions
and/or the external appearance of the equipment, damage is detected, immediately contact the
dispatch company or the retailer. The declaration of damage must be carried out within 6 days
of the product receipt and the carrier must be notified directly. If the product must be sent back
to the manufacturer, please use the original packaging.
Danger of injuries following mechanical damage
Mechanical damage to electrical components poses a serious danger for people and
property. If you are unsure the packaging is completely intact or the product
contained within, contact the manufacturer before installation and/or commissioning.
20 OMAF9212 REV. A
Installation and start-up of KEOR XPE UPS
Installation et démarrage de l'ASI KEOR XPE
Installazione e avviamento KEOR XPE UPS