Maintenance Summary Table - Grillo FD900 4WD Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DIESEL DECANTING DEVICE
The decanting device (fig. 40) prevents liquid impurities in the diesel or water from depositing on the bottom and
therefore from getting in contact with engine parts. Inside the decanting device there's a red ring raising upwards if
the quantity of impurities increases. Clean the decanting device very often, washing the inside with clean diesel too.
Check the decanting device at every use. Important: when filling up the diesel tank, always use a very fine filter.
CLEANING
Clean the deck, the entry ducts and the grass catcher. Do not wash the engine compartment with water under
pressure, use compressed air or a vacuum cleaner.
TOW HITCH
The tow hitch is located at the rear of the mower. The max. towing weight is 200 kg on flat ground.
TOWING THE MACHINE WITH SWITCHED OFF ENGINE
Important: To tow the machine in case of engine failure unscrew by three turns the screw on the hydrostatic pump
(fig. 41) using a 17 mm key; pay greater attention because doing so the efficiency of the self-braking device is
cancelled. Tow the machine at very low speed and only on small distances, maximum 100 metres, to avoid
seizing the hydraulic pump or engine.
STORAGE AND LACK OF USE FOR LONG PERIODS
Store the machine in a dry environment, sheltered from bad weather conditions and, if possible, covered up. Clean
the machine from grass and/or ground residues.
red cable from the battery and follow the engine manual instructions. Remember to lubricate all the joints. Regularly
check that the battery voltage does not go under 12,5 Volts. If it is below, recharge the battery.
PROCEDURE
Engine oil
Check the level
Change
Air filter
Check
Replace
Hydraulic oil
Check the level
Replace
Check that the cooler intake grid is
clean
Check that blades are well
sharpened and well-fixed
Lubricate with grease
Diesel filter
Check
Replace
Deck gearbox
Replace
Diesel decanting device
recommended procedure
*
procedure to be carried out if necessary
Translation of the original instructions
If the machine is to be out of use for more than 30 days, detach the

MAINTENANCE SUMMARY TABLE

EVERY
8 HOURS
Check
AFTER THE
EVERY
FIRST
50 HOURS
20 HOURS
(first change)
16
EVERY
EVERY 250
100 HOURS
HOURS
*
(first change
after 500
hours, then
every 1000
hours)
*
(every 300
hours)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fd 90080365u

Table des Matières