Settings; Adjusting And Fastening The Opening Stop; Checking The Tension Of The Belt - SOMFY GDK 700 Notice D'installation Et D'utilisation

> Fastening the link arm to the door and the carriage (continued)
be necessary to cut the link arm.

1.4 Settings

> Adjusting and fastening the opening stop
During this operation, check that there is no risk that the back release device cable will subsequently become snagged
on an element protruding from the car (for example a roof rack).
1
• Release the carriage using the manual back release device
and move the door to the open position.
Do not open the door fully, but position it so that it does
not reach its stops.
> Checking the tension of the belt
• If necessary, adjust the belt tension.
1
2
I
• Position the stop against the carriage.
• Mark the mounting holes.
• Drill the holes with a
• Fix the stop using the self-tapping screws
obtain the correct tension, the rubber should measure
between 18 and 20 mm (see page 10).
Installation
2
door bracket must be as horizontal as
possible.
J
.
J
EN - GDK installation and operating guide - SOMFY
1
13