Setup; Meanings Of The Various Parameters - SOMFY DEXXO PRO io Manuel D'installation

Dexxo Pro io
> Remote lighting (Fig. 38)
Class 2 (double insulation) light units that are connected do not require an earth
connection.
Various types of lighting can be connected without exceeding a total power

7 - SETUP

7.1 Meanings of the various parameters

(Boldface text = default values)
Operating mode
Values 0 : sequential
Comments Automatic closure mode operation is only possible if
Orange warning light
Values 0: without advance warning
Comments
Safety input
Values 0: no safety mechanism
Comments
account.
of every operating cycle.
months.
Obstacle detection
sensitivity
Values
2: standard
obstacle detection complies with annex A of the standard EN 12 453.
Non-observance of this instruction can result in serious injury to
persons, e.g. when trapped by a door.
Partial opening cycle
Values 0 : not valid
Comments
Pressing the button programmed for partial opening causes
partial opening; pressing the button programmed for full
opening causes full opening.
previously programmed remote control button will
partially open the garage door; an additional command
must then be performed so that the button fully opens
controls for full and partial opening operation")..
t0
WARNING
Closing speed
Values
to
By default, 6: approx. 12 cm/s
Comments If spurious detection of obstacles occurs when this
programming will need to be repeated.
obstacle detection complies with annex A of the standard EN 12 453.
Non-observance of this instruction can result in serious injury to
persons, e.g. when trapped by a door.
Partially open position
Values Storing the position as illustrated in Fig. 40.
Values
1: standard (over approx. the last 30 centimetres)
Comments If spurious detection of obstacles occurs when this
programming will need to be repeated.
obstacle detection complies with annex A of the standard EN 12 453.
Non-observance of this instruction can result in serious injury to
persons, e.g. when trapped by a door.
Opening speed
Values
to
9: fastest speed: approx. 18 cm/s
Comments If spurious detection of obstacles occurs when this
programming will need to be repeated.
Choice of operating direction (type of door)
Values 0: direction 1: all types of doors except swinging doors
Comments
programming will need to be repeated.
Safety action prior to opening (safety ADMAP)
Values 0: no effect
Comments
door opening.
Safety action during closure
Values
3: fully reopen
Comments Value 1 is not allowed when using a sensor bar on the
safety input.
Obstacle detection action during closure
Values
3: fully reopen
Copyright © 2015 SOMFY ACTIVITES SA. All rights reserved
WARNING
WARNING