Preparing To Work - Stiga T 26 J Manuel D'utilisation

1.3 ASSEMBLY AND DISASSEMBLY
OF THE CUTTING LINE HEAD (Fig. 3)
a) Assembly
– B lock rotation of the shaft (1) with a proper
wrench.
– F it the cutting line head (1) screwing it clock-
wise.
c) Disassembly
– B lock rotation of the shaft (1) with a proper
wrench.
– R emove the cutting line head (2) unscrewing it
anticlockwise.
1.4 MOUNTING THE ROD (Fig. 4)
– P ull out the stop pin (1) and push the lower
part of the rod (2) right down until the stop pin
(1) clicks into the hole (3) in the rod. This is
easier to do if you rotate the bottom of the rod
(2) slightly in both directions. The pin (1) is in
place when it is completely lodged in the hole.
– O nce inserted, tighten the knob (4) securely.

2. PREPARING TO WORK

2.1 CHECKING THE MACHINE
Before starting work please:
– c heck that all the screws on the machine and
the cutting device are tightly fastened;
– m ake sure the cutting device is not damaged;
– m ake sure the protection devices are well fas-
tened and working efficiently;
– c heck the handgrips are well fastened.
2.2 PREPARING THE FUEL MIXTURE
This machine is fitted with a two-stroke engine
which requires a mixture of petrol and lubricat-
ing oil.
IMPORTANT Using petrol alone will damage the
engine and is cause for invalidation of the war-
ranty.
IMPORTANT Use only quality fuels and oils to
maintain high performance and guarantee the du-
ration of the mechanical parts over time.
2.2.1 Petrol characteristics
Only use unleaded petrol with a fuel grade of at
least 90 ON.
IMPORTANT Unleaded petrol tends to create de-
posits in the container if preserved for more than 2
months Always use fresh petrol!
2.2.2 Oil characteristics
Only use top quality synthetic oil specifically for
two-stroke engines.
Your Dealer can provide you with oils which have
been specifically developed for this type of en-
gine, and which are capable of guaranteeing a
high level of protection.
The use of these oils makes it possible to pre-
pare a 2,5% mixture, consisting in 1 part oil to
40 parts petrol.
2.2.3 Preparation and preservation
of the fuel mixture
DANGER! Petrol and the fuel mixture are
highly inflammable!
– K eep the petrol and fuel mixture in homolo-
gated fuel containers, in a safe place, away
from any flames or heat sources.
– Never leave the containers within the reach
of children.
– N ever smoke whilst preparing the mixture
and avoid inhaling the petrol fumes.
To prepare the fuel mixture:
– P lace about half the amount of petrol in a ho-
mologated tank.
– Add all the oil, according to the chart.
– Add the rest of the petrol.
– C lose the top and shake well.
IMPORTANT The fuel mixture tends to age. Do
not prepare excessive amounts of the fuel mixture
to avoid the formation of deposits.
IMPORTANT Keep the petrol and fuel mixture
containers separate and easily identifiable to
avoid the mistake of using one in place of the
other.
IMPORTANT Periodically clean the petrol and
fuel mixture containers to remove any eventual
deposits.
2.3 REFUELLING
DANGER! Never smoke whilst refuelling
and avoid inhaling the petrol fumes.
WARNING! Carefully open the tank top
as pressure could have formed inside.
Before refuelling:
– S hake the fuel mixture container well.
– P lace the machine on a flat stable surface,
with the fuel tank cap facing upwards.
– C lean the fuel tank cap and the surrounding
area to avoid any dirt from entering the tank
6