Setting Ranges For The Switching Outputs - HYDAC ELECTRONIC ENS 3000 Notice D'utilisation

ENS 3000
For the version with 4 switching points, the following menu appears:
→
→
2s
3s
NOTE:
• If "LOC" appears in the display when attempting to change a setting,
programming is disabled.
Action: Set the programming enable(s) to "free". (see section 11 Programming
Enables)
• If the ; key
advance automatically.
• Whenever any settings have been altered, "PROG" appears briefly in the
display when the display switches over. The new setting is then saved in the
unit.
8.4

SETTING RANGES FOR THE SWITCHING OUTPUTS

(switching point minus switching hysteresis = switch-back point)
Probe length
in cm
25.0
41.0
52.0
73.0
The increment for all units is 0.1 cm.
Probe length
in inch
9.80
16.20
20.50
28.70
The increment for all units is 0.05 inch.
Switching point
in °C *
-23.0 .. 100.0
Switching point
in °F *
-9 .. 212
* All ranges given in the table can be adjusted by the increments shown and apply when the
Status 19.09.2018
→
2s
or key is held down while changing a setting, the value will
Measuring range
in cm
17.0
29.0
39.0
59.0
Measuring range
in inch
6.70
11.40
15.35
23.20
Switching
hysteresis
in °C *
1 .. 123.5
Switching
hysteresis
in °F *
2 .. 222
HYDAC ELECTRONIC GMBH
HYDAC
→
2s
mode
Switching point
in cm *
0.3 .. 17.0
0.5 .. 29.0
0.6 .. 39.0
0.9 .. 59.0
Switching point
in inch *
0.10 .. 6.70
0.20 .. 11.40
0.25 .. 15.35
0.35 .. 23.20
Increment
in °C *
0.5
Increment
in °F
1
actual
display
Switching hysteresis
in cm *
0.1 .. 16.8
0.2 .. 28.7
0.2 .. 38.6
0.3 .. 58.4
Switching hysteresis
in inch *
0.05 .. 6.60
0.05 .. 11.25
0.05 .. 15.15
0.15 .. 22.85
offset is zero.
Part No. 669849
Page15