Changing The Main Programming Enable - HYDAC ELECTRONIC ENS 3000 Notice D'utilisation

ENS 3000

11.2 CHANGING THE MAIN PROGRAMMING ENABLE

CAUTION:
Switch off the supply voltage or disconnect the instrument from the supply
voltage.
HYDAC
→
mode
Press both arrow keys
simultaneously
and hold them down.
Switch on supply voltage.
(hold the keys down for
3 s)
(Data not changed)
(Data changed)
3 s
NOTE:
• Whenever any settings have been altered, "ProG" appears briefly in the
display when the display switches over. The new setting is then saved in the
unit.
Status 19.09.2018
→
0s
3s
Display
(release
arrow keys)
Fluid level indication
Pressure
3 s
bar
Fluid level indication
Pressure
3 s
HYDAC ELECTRONIC GMBH
HYDAC
mode
Use the or keys to alter the
settings
FrEE = programming enabled
Loc = programming disabled
Page23
Part No. 669849