Setting Ranges For Switching Outputs; Basic Settings; Altering The Basic Settings - HYDAC ELECTRONIC ETS 300 Notice D'utilisation

ETS 300
.4

SETTING RANGES FOR SWITCHING OUTPUTS

7
Switching point function
Sensor Unit
°C
ETS 320
°F
°C
ETS 380
°F
Window function
Sensor Unit
°C
ETS 320
°F
°C
ETS 380
°F
* All ranges given in the table are adjustable by the increments shown.
8

Basic settings

In order to adapt the unit to a particular application, the function of the ETS 300 can be altered via
several basic settings. These are combined in one menu.

8.1 ALTERING THE BASIC SETTINGS

NOTE:
• When the menu is activated no switching operations are carried out.
• Switch off supply voltage or disconnect the unit from the supply voltage.
To close the basic setting menu:
Call up the menu point "END", set to "YES", the ETS 300 returns to the normal display mode after
2 seconds.
NOTE:
• If after about 50 seconds no keys have been pressed, the menu automatically closes
down. Any changes which may have been made will not be saved.
Status: 29.01.2014
Display Switching point
-25 .. 100 -22 .. 100
-13 .. 212 -10 .. 212
-30 .. 150 -27 .. 150
-22 .. 302 -16 .. 302
Display Lower switch value
-25 .. 100 -23 .. 99
-13 .. 212 -11 .. 211
-30 .. 150 -28 .. 149
-22 .. 302 -18 .. 300
(for summary see 8.2)
HYDAC ELECTRONIC GMBH
Hysteresis Increment*
1 .. 123 1
1 .. 223 1
1 .. 178 1
2 .. 320 2
Upper switch Increment*
value
-22 .. 100 1
-10 .. 212 1
-27 .. 150 1
-16 .. 302 2
Part No.: 669651 E
9