Summary Of The Basic Settings - HYDAC ELECTRONIC ENS 3000 Notice D'utilisation

ENS 3000
9.2

SUMMARY OF THE BASIC SETTINGS

Setting
Switching output 1 assignment (S.S.1)
Switching output 1 to switch at the
pre-set fluid level
Switching output 1 to switch at the
pre-set temperature
Switching mode, switching output 1 (S.m.1)
Switching output 1 is operating in
switching point hysteresis mode
Switching output 1 is operating in
window mode
Switching direction, switching output 1 (S.d.1)
Normally open
Normally closed
Switch-on delay, switching output 1 (T
Time in seconds which must elapse once the
particular switch point has been reached or
exceeded before switching will occur.
Increment: 1s
Switch-off delay, switching output 1 (T
Time, in seconds, which must elapse once
the value has dropped below the switch
back point before a switching operation
will occur.
Increment: 1s
Settings for switching output 2, 3 or 4 are carried
out as discribed above
Primary display (Primary)
Value to be continually displayed:
Anzeige stehen soll:
Actual fluid level
Peak fluid level
Lowest fluid level
Actual temperature
Peak temperature
Lowest temperature
up
to
Display off
(For function, see Section 7. "Digital display")
Status 19.09.2018
ON
OFF
Switch point 1 to 4
HYDAC ELECTRONIC GMBH
Display
1)
1)
Setting range Default
setting
niv / TEMP niv
SP / Win SP
ON / OFF ON
0 .. 9999s 1
0 .. 9999s 1
niv/ niv
n.Top/
n.Min/
Temp/
T.Top/
T.Min/
S.P.1/
S.P.2/
S.P.3/
S.P.4/
OFF
Part No. 669849
Page18