Operating Keys Of The Ens 3000; Digital Display - HYDAC ELECTRONIC ENS 3000 Notice D'utilisation

ENS 3000
6

Operating keys of the ENS 3000

1 or 2 Switching points
HYDAC
°C °F
SP1
cm
mode
Buttons for setting
the switching points, switch-back
points
7

Digital display

After switching on the supply voltage "ENS" appears for about 2 seconds in the display,
followed by the actual set fluid, level or temperature and then begins to show the actual
value (basic setting).
1 or 2 Switching points
4s
4 Switching points
4s
If the level exceeds or falls below the measuring zone of the electronic level sensor, the
following sequence is displayed:
1 or 2 Switching points
4s
4 Switching points
4s
NOTE:
• If level is too low: top up the fluid until a valid measurement is detected.
• If level is too high: drain the fluid until a valid measurement is detected.
Status 19.09.2018
Display of
temperature units
4-digit
Digital display
Display of
fluid level unit
SP2
LED-Display of
the active switching
2s 2s
2s 2s
2s 2s
2s 2s
HYDAC ELECTRONIC GMBH
4 Switching points
HYDAC
°C °F
SP1
1 2
3 4
mode
Buttons for setting
the switching points, switch-back
points
2s
flashing display
2s
Display of
temperature units
4-digit
Digital display
SP2
LED-Display of
the active switching
point
flashing display
Part No. 669849
Page11