HYDAC ELECTRONIC ENS 3000 Notice D'utilisation page 55

ENS 3000
Setting
Setting the indication range of the fluid level (FLUID LEVEL RANGE)
The fluid level is indicated in
inch
The fluid level is indicated
in cm
Setting the level offset (NIVEAU OFFSET) while the fluid level is displayed
The distance between the base of the tank
and the start of the active zone of the fluid
level sensor is regarded as the "offset".
Inputting this distance will generate a
reference to actual fluid level.
Setting the indication range of the temperature (TEMPERATURE RANGE)
The temperature is shown in °F.
The temperature is shown
in °C.
Setting the type of fluid
Fluid level sensor calibrated to oil
parameters
Fluid level sensor calibrated to
cooling lubricants parameters
(Aqueous cooling Lubricants =
AcL)
When the new selection is saved, the change is active. On the version with 4 SP the
message is also displayed.
Assigning the analogue output (Select Output)*
The analogue output is
assigned to the fluid level
Assigns the analogue output to
temperature.
Status 19.09.2018
Display
HYDAC ELECTRONIC GMBH
Setting range Default
setting
inch/ cm
cm (dependi
ng on the
model)
0
Fahr/ celc celc
(dependi
ng on
version)
oil/ AcL oil
niv/ TEMP niv
Part No. 669849
Page19