HYDAC ELECTRONIC ENS 3000 Notice D'utilisation page 56

ENS 3000
Setting
Analogue output (Output)
The analogue output
provides a 4 .. 20 mA signal for
the active measuring range
The analogue output
provides a 0 .. 10 V signal for the
active measuring range
NOTE: relevant for replacement of "previous" devices only
In addition to the probe lengths 410 mm
and 520 mm, when the analogue output
has been assigned to the fluid level.
The analogue output provides a
.
4 .. 20 mA signal for a active
measuring range reduced by 30 mm
The analogue output provides a
.
0 .. 10 V signal for a active measuring
range reduced by 30 mm
Particular in the variant with 4 SP:
The analogue output provides a
0 .. 10 V signal for the active
measuring range of the fluid level
The analogue output provides a
.
0 .. 10 V signal for a active measuring
range reduced by 30 mm
Re-setting the measuring probe to factory settings**
The factory settings are not active
The factory settings are active
When the new selection is saved, the message
active.
Status 19.09.2018
Display
HYDAC ELECTRONIC GMBH
Setting
range
MAMP/
VOLT/
MA.Sr/
VO.Sr
VOLT/
VO.Sr
YES/ NO
is displayed and the change is
Page20
Default
setting
MAMP
VOLTS
NO
Part No. 669849