Stiga TITAN 540 D Mode D'emploi page 81

Check that the warning triangle is al-
ways taken when travelling.
3.3.3 Safety belt (1:G)
Aways use the safety belt when driving the ma-
chine.
3.3.4 Protective frame (1:N)
The machine is equipped with a protective frame.
Always drive with the protective frame
in upright position. Only fold the frame
when driving on a level surface and the
frame has to be folded for the machine
to be able to pass
3.4 CONTROLS
The descriptions of the controls are gathered by
how they are placed in the machine.
Controls - seat
See 3.4.1
Controls – steering bracket and ped-
als
See 3.4.2
Controls – instrument panel
See 3.4.3
Controls - other
See 3.4.4
3.4.1 Controls - seat
The seat is equipped with a safety switch that is
connected to the machine's safety system. This
means that certain dangerous activities are not pos-
sible when there is nobody sitting on the seat. See
also 5.7.2.
3.4.1.1 Adjusting seat backwards/forwards
(1:A1)
1. Move the control lever (1:AJ) upwards.
2. Set the seat to the desired position.
3. Release the control lever to lock the seat.
3.4.1.2 Adjusting seat suspension (1:A2)
The suspension of the seat can be adjusted accord-
ing to body weight using the knob.
Harder suspension: Turn the knob clockwise.
Softer suspension: Turn the knob anticlockwise.
The suspension setting can be read off from the in-
dicator (1:J2) by the knob. At correct setting the in-
dicator shows green.
3.4.1.3 Adjusting the backrest angle (1:A3)
The backrest can be adjusted to the desired angle
using the knob.
ENGLISH
3.4.1.4 Adjusting the armrest (1:A4)
The armrest can be adjusted to the desired angle
using the knob under the relevant armrest.
3.4.1.5 Storage compartment (1:F)
A storage compartment is located under the seat.
3.4.2 Controls – steering bracket and ped-
als
3.4.2.1 Steering wheel (1:B1)
Do not adjust the steering wheel during
operation.
The steering wheel can be raised and lowered and
set at different angles smoothly. See 3.4.2.5 and
3.4.2.2.
3.4.2.2 Adjusting steering wheel height (1:B2)
Do not adjust the steering wheel during
operation.
The height of the steering wheel is steplessly ad-
justable.
Undo the knob on the steering column and raise or
lower the steering wheel to the desired position.
Tighten.
3.4.2.3 Headlight (1:B3)
Pull the switch to activate the headlight (1:H).
Push down to turn headlight off.
3.4.2.4 Adjusting steering wheel angle (1:B4)
Do not adjust the steering wheel during
operation.
The steering wheel can be set at different angles
steplessly
Release the control on the side of the steering col-
umn and set the steering wheel to the desired an-
gle. Tighten the control.
3.4.2.5 Drive / service brake (1:B5)
If rapid deceleration becomes necessary
the pedal should be reversed sharply.
NOTE! This makes the operator
affected by powerful forces.
Never press the drive pedal when
parking brake is activated. This puts
unnormal load on the parking brake
and shortens its service life.
The pedal determines the gear ratio between the
engine and the driven wheels (= speed). The
service brake is activated when the pedal is
released or pressed towards neutral position.
Original instructions for use
EN
81