Pads For Full Length Safety Sides Cm-Acc03 & Cm-Acc26 - arjo Minuet 2 Notice D'utilisation

Pads for full length safety sides CM-ACC03 & CM-ACC26
These washable pads may be used with any of the full-length safety sides. They
may also be used when height extensions are fitted to the safety sides.
The pads are easy to fit, and can be removed from the bed quickly if the safety
sides need to be lowered in an emergency.
Model CM-ACC26 provides additional protective padding along the top rail.
Installation
Raise the safety side to its full locked height at both ends of the bed. Pull apart
the five hook and loop straps (A) to release the flap (B).
Position the safety side pad (C) on the bed. It should be fitted between the
mattress and the safety side, with the flap on the outside of the safety side top
rail (or the outside of the height extension rail, if fitted).
CM-ACC26 only: make sure the padded section of the flap lies over the top rail
as shown (D).
Fasten the five hook and loop straps to secure the pad to the safety side.
B
The diagram shows the safety side pads fitted to full length wooden
safety sides. Use a similar method when fitting the pads to full length
steel safety sides CM-ACC04.
Cleaning
Refer to the instruction label attached to the product.
Accessory Weight – pads for full length safety sides (per pair)
CM-ACC03 & CM-ACC26
A
C
3.9kg
33