arjo Minuet 2 Notice D'utilisation page 16

3
4
Slide the two side tubes of the head-end mattress platform section over
the arms on the head end panel assembly.
Fit socket head screws into the two holes (D) on the underside of the head
end mattress platform and fix the sections together, fitting the bottom
screw first. Tighten both screws firmly.
Use suitable packing material, e.g. cardboard, to raise the mattress
platform sections off the floor by about 1cm; this will help in aligning the
fixing holes correctly.
Unwrap the mains cable from around the slot (E) on the head end
mattress platform section.
Take care not to pinch hands or fingers, or trap any cables, when
sliding the bed sections together.
Lay the head end panel section on the
floor with the two arms on the frame (C)
pointing outwards towards the right as
shown.
Position the bed so that you can work on
C
the underside of the mattress platform
whilst assembling the bed. This will make
it easier to connect the actuators to the
control box.
D
WARNING
D
E
15