arjo Minuet 2 Notice D'utilisation page 28

Operation
D
Always hold the plastic moulding at one end of the top rail when raising or
lowering the safety side. Do not allow the safety side to drop as this may
damage the safety side.
Accessory weights – full-length safety sides (per side)
CM-ACC00.14
CM-ACC00.52
CM-ACC04.52
Secure the safety side fixing bracket to the
underside of each end panel, using two M8
x 16mm socket head screws (B). Make
sure both these screws are fully tightened.
Fully tighten the two top fixing screws (A).
Repeat this procedure to fit the other safety
B
side on the opposite side of the bed.
C
To lower the safety side:
Hold the plastic moulding (C) at the foot
end of the bed and lift the rail slightly.
Press and hold the release button (D) on
the safety side end pillar.
Lower the safety side to its bottom position.
Repeat this procedure at the head end of
the bed.
C
To raise the safety side:
Hold the plastic moulding (C) at the foot
end of the bed and pull the top rail
upwards until the safety side locks
automatically in the raised position.
Repeat this procedure at the head end of
the bed.
WARNING
11.0kg
10.0kg
12.0kg
27