arjo Minuet 2 Notice D'utilisation page 20

12
Check that all six socket head screws holding the bed sections
together are fully tightened.
Carefully turn the bed upright onto its castors.
Remove the plastic ties used to secure the backrest and leg
sections to the bed frame during transit.
Connect the mains plug to a suitable outlet socket.
Install the mattress retainers on the backrest and leg sections -
13
refer to Chapter 5 for fitting instructions.
Refer to Chapter 4. Check that all the bed's electrical functions
operate satisfactorily over their full range of movement. Make sure
that no cables become stretched or trapped in the bed mechanism
during operation.
Install a suitable, compatible mattress on the bed.
The bed is now ready for use. Read the following chapters for guidance on
using the bed and fitting the optional accessories.
Thread the cables from the
actuators and control handset
through the holes in the retaining
strip.
Push the retaining strip over the
connector plugs, until the two lugs
on the retaining strip "click" into
position in the two holes in the
control box.
The retaining strip will also help to
secure the backup battery in
position.
19