Folding Steel Safety Sides - arjo Minuet 2 Notice D'utilisation

Folding steel safety sides

These instructions illustrate the fitting of safety sides model CM-
ACC06.52. Extra height folding safety sides CM-ACC07.52 are fitted
and used in the same way. Extra height safety sides should be used
when the mattress thickness is between 150mm and 172mm (Refer
to page 12).
The folding safety sides are supplied as a pair to fit the right and left hand
sides of the bed, as viewed from the head end. These illustrations show the
left-hand safety side.
Installation
Position the safety side initially with it tilted towards the middle of the
bed. When both brackets are correctly located on the bed frame,
rotate the complete safety side assembly back to the vertical.
A
Position the safety side assembly on
the side frame of the bed, with the
two fixing brackets hooked over the
top of the bed frame.
The spacer bar (A) must fit behind the
edge of the head end panel as
shown; this will ensure the safety side
is correctly positioned on the bed.
30