arjo Minuet 2 Notice D'utilisation page 30

Installation
A
D
Accessory weights – safety side height extensions
CM-ACC02-1.52
CM-ACC02-3.52
Raise the safety side and position the
height extension on the safety side with
the fixing clamps over the top rail.
Push the fixing pin (A) through the larger
of the two holes in the fixing clamp (B), so
that the fixing pin passes under the safety
B side top rail.
Secure the fixing pin in position by fitting
an M8 socket head screw (C)
through the smaller hole on the other side
of the fixing clamp.
Do not tighten the screw fully at this
C
stage.
Repeat this procedure for both fixing
clamps.
Slide the height extension assembly
along the safety side top rail until the
distance (D) between the height
extension and the bed end panel is the
same at both ends of the bed.
Fully tighten the two socket head screws
(C) to secure the height extension in
position.
Repeat this procedure to install the other
height extension on the opposite side of
the bed.
3kg each
3kg each
29