arjo Minuet 2 Notice D'utilisation page 51

Remove the two socket head fixing screws securing the foot end
mattress platform section to the bed.
7
Pull the foot end mattress platform section away from the bed, taking
care not to trap or pinch the actuator cables, and lay it on the floor.
Remove the two socket head fixing screws securing the head end
mattress platform section to the head end panel section.
Pull the two sections apart, taking care not to trap or pinch the actuator
cables, and lay both sections on the floor.
8
Coil up all the actuator cables neatly and secure with suitable plastic ties.
Coil the mains cable around the control box and the slot in the head end
mattress platform section.
Lie the head end panel section (B) on its
side.
Position the foot end panel (C) section,
also on its side, so that both fixing arms
overlap as shown in the diagram.
Fit the transit brackets (D) down over
9
the fixing arms. Both transit brackets
must be fitted with their open sides
pointing towards the floor.
Line up the holes in each transit bracket
with the holes in the end panel section
fixing arms.
Use four M8 socket head screws to secure the both end panel sections
onto the transit brackets. Fasten the screws finger tight at first, then
10
tighten them fully using a 5mm Allen (hexagon) key once all four screws
are in place.
D
C
D
B
50