arjo Minuet 2 Notice D'utilisation page 19

P
9
Q
10
Plug the control handset into the control box socket marked with
the symbol shown on the left.
Make sure the handset plug is pushed fully into the socket and
that the sealing ring is not visible.
The label on the control box indicates the function of each
socket:
11
Insert a small flat-bladed
screwdriver into the two slots (O)
and prise open the clips holding the
retaining strip (P) onto the control
box.
O
Pull off the retaining strip and keep
it safe.
Do not unplug the cables
connected to the control box
sockets marked 1 and 3.
Plug the cable labelled 2 into the
control box socket marked 2.
Plug the cable labelled 4 into the
control box socket marked 4.
Make sure all the actuator plugs
are pushed fully into their sockets
and that the sealing rings (Q) are
not visible.
18