arjo Minuet 2 Notice D'utilisation page 59

Electrical data
Power input
Duty rating
Electric shock protection
EMC
Backup battery
Typical lifetime
Backup duration
Liquid ingress protection
End of Life Disposal
Equipment that has electrical and electronic components should be disassembled
and recycled per Waste of Electrical and Electronic Equipment (WEEE) or in
accordance with local or national regulation.
All batteries in the product must be recycled separately. Batteries are to be
disposed in accordance with national or local regulations.
Components that are primarily made up of different kinds of metal (containing more
than 90% metal by weight) for example bed frame, should be recycled as metals.
Transportation and storage
Handle with care. Do not drop. Avoid shock or violent impact.
This equipment should be stored in a clean, dry and well-ventilated area which
meets the following conditions:
Temperature
Relative humidity
Air pressure
If the bed is stored for a long time, every three months it should be
connected to the electricity supply for 24 hours to recharge the backup
battery. Failure to do this may reduce the life of the battery.
1A max. 230V a.c. 50Hz
Intermittent 10% (2 min. on, 18 min. off)
Class II
Complies with EN 60601-1-2
12V, 1.2Ah sealed rechargeable lead/acid
gel
4 years max.
6 full lift / lower cycles with SWL
IP24 (2-Protection against solid particle
ingress larger than 12.5mm – fingers or
similar objects. 4-Protection against liquid
ingress – water splashing against the
enclosure from any direction shall have no
harmful effect).
-10 C to 50 C (-14°F to 122°F)
20% to 90% non-condensing
800 to 1060hPa
Caution
Type B
58