Preparation For Use; Mattress Installation; Atmosair With Sat 4000, 9000, Atmosair With Sat T-Series* And Atmosair With Sat A-Series - arjo AtmosAir 4000 Série Mode D'emploi

Preparation for Use

EN
1. Open shipping container(s).
2. Remove AtmosAir with SAT MRS from plastic protective cover.
3. Check mattress surface for tears or cracking; do not use if tears or cracks are
present.
4. If re-installing mattress onto a new frame or for a new patient, check mattress
surface for staining and soiling; clean and / or disinfect as required (see Care and
Cleaning).
5. Level bed and lock brakes.
6. Remove existing mattress from bed frame.

Mattress Installation

AtmosAir with SAT 4000, 9000, AtmosAir with SAT T-Series*
and AtmosAir with SAT A-Series
1. Position mattress on bed frame with logo facing up and product information tags
at foot end of bed.
2. Ensure there are no gaps between mattress and bed frame or side rails.
* T-Series is compatible for use with the Hill-Rom Total Care™ bed frame.
6
For information concerning the bed frame refer to the manufacturers'
User Guide.
Do not use sharp instruments to open boxes. Damage to mattress
could result.
The mattress cover may appear wrinkled when unpacked. To remove
wrinkles, allow mattress up to 24 hours to accommodate; see
Troubleshooting
or function, so mattress may be used immediately if needed.
Magnets are integrated on the AtmosAir T-Series bottom cover to help
keep the mattress in place during foot section extension / retraction.
Always use a standard healthcare bed frame with safeguards or
protocols that may be appropriate. Frame and side rails must be
properly sized relative to the mattress to help minimize any gaps that
might entrap a patient's head or body.