arjo Minuet 2 Notice D'utilisation page 41

C
B
D
E
F
Do not allow the control handset cable to become trapped in the bed
mechanism when the bed is operated.
This accessory must only be fitted to the bed in the way described
above.
Do not use this accessory for any purpose other than storing the control
handset.
Accessory weight – flexible handset holder
CM-ACC13
Position the lower clamp section below the
bed frame, with the clamp tube (B) on the
outside of the bed as shown.
Fit two M6 socket head screws (C) down
through the clamp plate (A) into the
threaded holes in the lower clamp section
A
(B). Make sure the screws are fully
tightened.
Check that both sections of the clamp fit
tightly against the side frame of the bed to
prevent the clamp moving in use.
Fit the handset holder pole (D) into the
clamp tube (B). Make sure the notch (E)
locates on the pin (F) at the bottom of the
clamp tube.
Slide the control handset down into the
holster with the pushbuttons facing
outwards. The clip on the back of the
handset will help to retain it in the holster.
Adjust the flexible arm to position the
handset in the most comfortable and
convenient position for the patient.
Caution
WARNING
1.1kg
40