Storing Of The Product; Accessories; Product Warranty; Warranty - Boston Scientific Swiss LithoClast Select Mode D'emploi

STORING OF THE PRODUCT

Keep the original packaging until the product is to be disposed
of permanently. You can use it for shipping or storing at any time.
Should you wish to store the product for an extended period of time:
• Proceed as described in the chapter "Cleaning, disinfecting and
sterilizing",
• Pack the product and all accessories in the original packaging.
Please refer to the storage and transport conditions in the "Technical
data".

ACCESSORIES

Accessories are available from Boston Scientific Customer Service.
For safety reasons this product may only be used with genuine
Swiss LithoClast Select System accessories. The user assumes all
®
risks of using this product with non-genuine accessories or otherwise
in non-compliance with the instructions manual.

PRODUCT WARRANTY

The warranty is valid for one year from the date of purchase.
Damages due to non-adherence to the operating instructions or wear
out of parts are excluded from warranty.
The warranty of the product will be cancelled if you try to open
or disassemble it.
34
FB-411_US_ed_2013_10_Not_Swiss LithoClast Select BSC.indd 34

Warranty

The manufacturer warrants that reasonable care has been used in
the design and manufacture of this instrument. This warranty is
in lieu of and excludes all other warranties not expressly set
forth herein, whether express or implied by operation of law or
otherwise, including, but not limited to, any implied warranties
of merchantability or fitness for a particular purpose. Handling,
storage, cleaning and sterilization of this instrument as well as other
factors relating to the patient, diagnosis, treatment, surgical procedures
and other matters beyond the manufacturer's and/or BSC's control
directly affect the instrument and the results obtained from its use. The
manufacturer's obligation under this warranty is limited to the repair or
replacement of this instrument if deemed by the manufacturer to be
defective in material or workmanship, and neither the manufacturer nor
BSC shall be liable for any incidental or consequential loss, damage,
or expense directly or indirectly arising from the use of this instrument.
The user assumes responsibility for any consequences which may
arise pertaining to the use of the products. BSC and the manufacturer
neither assume, nor authorize any other person to assume for it, any
other or additional liability or responsibility in connection with this
instrument.
Swiss LithoClast is a registered trademark.
®
6/3/2015 2:33:56 PM