Air intake
not connected
Picture 11 - Possible connections of the air intake of the cooker
To make the connection easier we suggest
to make the external air intake on the floor
in correspondence with the internal part of
the plinth, or on the wall through the rear
WARNING! Aspiring hoods or extracting air fans in the room may generate
problems to the device if there is not a suited air intake or in case of air intake
sub-dimensioned.
A
External air entry
B
Picture 12 - Rear sight of the plinth of the wood fired cook-
er and specifies for the connection with the air
intake through the plinth. The clear part rep-
resents the standard opening in which you can
insert the pipe for the connection.
2.11
ELECTRIC CONNECTIONS
ZV Range cookers have to be fed for the
oven lamp. The connection to AC power
must be done by experienced people and
according with existing laws. The installer
is responsible of the correct connection ac-
cording with safety rules. To make the con-
nection, you have to connect an electric ca-
ble to the terminal board placed in the rear
Air intake
on the floor
H
C
B
Air intake external
part of the cooker according to specifies de-
pending on the model (see table n. 2 and
picture n. 12).
Measures
Models
A
ZV 60
97
ZV 90
97
Table 2 - Dimensions for the connection of the external air
intake
side of the cooker. Must be done the correct
connections of line, neutral and earth as de-
scribed in the picture n. 14. The cable and
every other electric device
added must be dimensioned for the electric
load to sustain and must not be in contact
with points 50° C hotter than ambient tem-
perature.
70
on the wall
ø
B
C
H
46
500
240
95
46
800
240
95