Publicité
2 Installing the Instrument
Before Installation or Use
Inspect the Unit
Upon receipt of the RPS unit, inspect it for any obvious shipping damage. If there is damage, notify the
shipping carrier and nearest Keysight Sales and Support Office immediately
/find/assist). Save the shipping carton and packing materials in case the unit has to be returned.
Check for Items Supplied
Before getting started, check the following list and verify that you have received these items. If
anything is missing, please contact your nearest Keysight Sales and Support Office.
Supplied Items
Sense connector plug with cable
(installed)
Sense connector plug (installed)
Cover kit - Includes:
Digital connector plug
Primary/secondary cable
AC input safety cover
Output safety cover
Ferrite core
ESD cover with flange
Bus bar connection kit
Calibration certificate
Review Safety Information
This power supply is a Safety Class 1 instrument - with a protective earth terminal. This terminal must
be connected to earth ground through an ac mains equipped with an earth ground. Refer to the
Summary
page for general safety information. Before installation or operation, always review this
guide for specific safety warnings and instructions located at appropriate places throughout the guide.
SHOCK HAZARD, LETHAL VOLTAGES - Many models generate output voltages up to
2,000 VDC! Ensure that all instrument connections, load wiring, load and sense
connections are insulated using high-voltage wire. Always attach the safety cover
provided, so that no accidental contact with lethal voltages can occur.
64
Description
4-pin high-voltage sense connector plug with
2-wire high-voltage cable for +/ - voltage sense
4-pin high-voltage sense connector
(The two center terminals are not used)
8-pin connector for the digital port
1 m cable (CAT6A) for parallel communication
AC input safety cover with strain relief bushing
High voltage output bus bar safety cover
Ferrite core installs on the output cables
(for RP7973A, RP7982A, RP7983A)
ESD cover for remote interface connections
Connection hardware for high voltage bus bars
Calibration certificate referenced to serial number
Keysight RP7970 & RP7980 Series Operating and Service Guide
(www.keysight.com
Part Number
Keysight 5188-9651
Plug only: Keysight 0360-3228
(Phoenix Contact 1714294)
Keysight 0360-3228
(Phoenix Contact 1714294)
Keysight 5066-2117
Phoenix Contact 1840421
Keysight 5067-6031
None
Safety
Publicité
