Publicité
4 Using the Regenerative Power System
Clear Output Protection
If an over-voltage, over-current, over-temperature, power-fail, power-limit, inhibit, or any other
protection condition occurs, the output is disconnected into a high-impedance state. The appropriate
operating status indicator on the front panel will be on. To clear the protection function and restore
normal operation, first remove that condition that caused the protection fault. Then, clear the
protection function as follows:
Front Panel Menu Reference
Select Protect\Clear
Select Clear.
The output is re-enabled once the output protection function is cleared.
128
SCPI Command
To clear a protection fault:
OUTP:PROT:CLE
Keysight RP7970 & RP7980 Series Operating and Service Guide
Publicité
