• To remove protective films and advertisement stickers on front sur-
face of the oven before first usage
ELECTRICAL WARNINGS
• The socket must be suitable for the load indicated on the tag and
must have ground contact connected and in operation. The earth
conductor is yellow-green in colour. This operation should be carried
out by a suitably qualified professional.
• Connection to the power source can be made by plug or by fixed wir-
ing placing an omnipolar breaker, with contact separation compliant
to the requirements for overvoltage category III, between the appli-
ance and the power source that can bear the maximum connected
load and that is in line with current legislation.
• ln case of incompatibility between the socket and the appliance plug,
ask a qualified electrician to substitute the socket with another suita-
ble type. The plug and the socket must be conformed to the current
norms of the installation country.
• The yellow-green earth cable should not be interrupted by the break-
er. The socket or omnipolar breaker used for the connection should
be easily accessible when the appliance is installed.
• lf the supply cord is damaged, it must be replaced by the manufactur-
er, its service agent or similarly qualified persons in order to avoid a
hazard. For any repairs, refer only to the Customer Care Department
and request the use of original spare parts.
• Disconnect the appliance from the mains electricity supply before
carrying out any work or maintenance on it.
•
WARNING: ensure that the appliance is switched off before re-
!
placing the bulb, to avoid the possibility of electric shocks.
• The oven must be switched off before removing the removable parts.
After cleaning, reassemble them according the instructions.
• The use of any electrical appliance implies the observance of some
fundamental rules:
ശ do not pull on the power cable to disconnect the appliance from
the power source;
ശ do not touch the appliance with wet or damp hands or feet;
ശ in general the use of adaptors, multiple sockets and extension
cables is not recommended;
EN 7