SilverCrest 411302 2207 Mode D'emploi page 14

Clean the containers 3 and the base 4 in a mild soapy solution. Rinse the
■
parts afterwards with fresh water so that all detergent residues are removed.
NOTE
►
■ Dry all parts well.
Storing the appliance
■ Store the cleaned appliance in a clean and dry location.
Troubleshooting
Problem
The appliance
is not working.
The appliance
switches itself
off automat-
ically during
operation.
If the malfunction cannot be corrected using any of the suggestions above or if
you have found some other kind of malfunction, please contact our Customer
Service department.
SDAG 250 A1
The containers 3 and the base 4 can also be cleaned in the
dishwasher. If possible, place the parts in the upper dishwasher
basket and do not jam them in.
Possible causes
The appliance is not connect-
ed to a mains power socket.
The appliance is damaged.
The thermal cut-out has been
triggered.
The ventilation slots may be
blocked or the appliance
may not have clearance from
surrounding objects.
Possible solutions
Connect the appliance to a
mains power socket.
Contact the Customer Service
department.
Disconnect the plug and
allow the appliance to
cool down. Make sure that
the ventilation slits are not
blocked and that a clearance
of 30 cm is ensured on all
sides of the appliance.
GB │ IE │ 11 ■