Gima VITAL PRO SNET PC-900 Instructions D'emploi page 29

² "Mute 112
silenced for. shows that the alarm sound is enabled;
120 seconds; shows that the alarm sound is disabled.
Operation instruction:
Ø Short pressing the display view "
Ø Long press the display view "
Ø For monitor without ECG function, hold Auxiliary key "
this it can lock / unlock key operation. For monitor with ECG function, hold ECG lead key "
press NIBP setup key "
Note: This function is available in any screen view, we will not cover it again in the following.
Ø Short press the print key "
the printer is installed.
The following operation is also for the monitor with ECG function.
Ø Pressing OK "
Ø
Short pressing Lead "
Ø Short pressing Up/Down("
Note: there are 7 screen views (depending on your configuration): default screen, screen for real-time ECG waveform
only, NIBP list screen, SpO
The following sections will describe each one of these 7 screens.
4.3 Screen for Real-time ECG waveform Only (Optional)
Note: this screen is only for the monitor with ECG function.
Real-time ECG waveform screen is as shown in figure 4.3.
² "II": ECG lead.
² "X2": ECG waveform gain.
Operating instructions:
Ø
Pressing OK "
": display the status of the alarm silence, and the counting down the time that the alarm sound is
" key to shift screen views.
" key to enter into Menu setup screen.
", by doing this it can lock / unlock key operation.
" to activate printing with the format specified by "Setup Menu→System→Print" if
" key to freeze / unfreeze ECG waveform.
" key to shift the ECG lead.
" / " " ) key to change ECG waveform gain.
data list screen, alarm event list screen, screen for graphic trend and ECG waveform recall.
2
Figure 4.3 Real-time ECG waveform screen
" key to freeze / unfreeze ECG waveform.
shows that the alarm sound is silent temporarily for
" firstly, then press NIBP setup key "
23
", by doing
" firstly, then
ECG waveform