Gima VITAL PRO SNET PC-900 Instructions D'emploi page 68

before putting the monitor into storage.
% Using a monitor powered solely by an internal battery power which has short charge power will cause the
monitor turn off automatically when the battery is depleted.
% Do NOT use batteries manufactured by other companies, which may cause damage to the device;(If
battery is damaged, please replace with same type and specification battery marked by "CCC" or "CE"
in time, or contact the company directly. )
10.1.4 Service
If the monitor malfunctions and you are not able to resolve an issue using the troubleshooting guide, please contact the
supplier. Only qualified service engineers, specified by the manufacturer can perform maintenance and users are not
permitted to repair the monitor or conduct maintenance by themselves.
10.2 Cleaning and Disinfection
n Keep the monitor free from dust.
n It is recommended to regularly clean the outer shell and screen of the monitor to keep it clean.
Only a non-corrosive cleanser such as clear water is permitted.
n Wipe the surface of the monitor with a cloth slightly dampened with warm water and a mild, non-
corrosive detergent or an alcohol impregnated wipe. Dry with a clean cloth or simply air-dry.
n The monitor can be sterilized and disinfected, please clean it first.
M Switch off the monitor and disconnect the power cable before cleaning.
M Do not let the liquid cleanser flow into the connector jack of the monitor to avoid damage.
M Clean the exterior of the connector only.
% Dilute the cleaning product in line with the manufacturer's instructions.
% Do not let any liquid flow into the shell or any other part of the monitor.
% Do not leave any cleanser or disinfectant on the surface of the monitor.
% Do not perform high pressure sterilization on the monitor.
% Do not submerge any parts of the monitor or its accessories in the liquid.
% If the monitor accidentally becomes wet, it should be thoroughly dried before use. The rear cover can be
removed by a qualified service technician to verify absence of water.
% Do not pour the disinfectant onto the monitor surface while disinfecting.
10.3 Cleaning and Disinfection of Accessories
It is recommended to clean the accessories (including sensor, leads and plugs) with a piece of gauze which has been
soaked in 75% Alcohol or 70% Ispropanol before use.
M Do not use damaged accessories.
M Accessories can not be entirely immerged into water, alcohol or cleanser.
M Do not use radial, steam or epoxyethane to disinfect accessories.
M Wipe off any remaining alcohol or ispropanol on the accessories after disinfection, for good maintenance
can extend the life of accessories.
62