6.2 TEMP Monitoring
1. TEMP measuring range: 21.0℃~50.0℃
2. TEMP measuring accuracy: not greater than 0.2 ℃ for TEMP measuring range from 25.0
3. TEMP responding time: ≤150s for KRK sensor; ≤40s for YSI sensor
6.3 NIBP Monitoring
1. Measuring method: Oscillometric Technique
2. Pneumatic pressure measuring range: 0 mmHg~300mmHg
3. Accuracy of pressure measurement: ±3 mmHg
4. Cuff inflation time: <10 seconds (typical adult cuff)
5. Average measurement time: < 90 seconds
6. Air release time while the measurement is canceled: ≤2 seconds (typical adult cuff)
7. Initial cuff inflation pressure
Adult: 175 mmHg
8. Overpressure protection limit
Adult: ≤ 300 mmHg
9. NIBP measurement range:
press(unit)
SYS
mmHg
MAP
mmHg
DIA
mmHg
10. NIBP measurement accuracy:
Maximal mean difference: ±5 mmHg
Maximal standard deviation: 8 mmHg
Measurement mode: Manual, Auto, STAT
6.4 SpO
Monitoring
2
1. Transducer: dual-wavelength LED
Wavelength: Red light: 663 nm, Infrared light: 890 nm.
Maximal optical output power: less than 2mW maximum average
2. SpO
measuring range: 35%~100%
2
3. SpO
measuring accuracy: Arms is not greater than 3% for SpO
2
*NOTE: Arms is the accuracy defined as root-mean-square value of deviation according to ISO 80604-2-61
4. Low perfusion performance: the declared accuracy is attained when the pulse amplitude modulation ratio is as
low as 0.4%.
6.5 Pulse Rate monitoring
1. Pulse rate measuring range: 30bpm~240bpm
2. Pulse rate measuring accuracy: ±2bpm or ±2%, whichever is greater.
6.6 Data Recording
1. Sensitivity selection tolerance: ±5%
2. Recording speed: 25mm/s
3. Recording speed accuracy: ±10%
pediatric: 135 mmHg
pediatric: ≤ 240mmHg
Adult
40~275
20~230
10~210
Neonate: 65 mmHg
Neonate: ≤ 150 mmHg
Pediatric
40~200
20~165
10~150
range from 70% to 100%
2
46
o
C~45.0 ℃
Neonate
40~135
20~110
10~95