Gima VITAL PRO SNET PC-900 Instructions D'emploi page 23

3.4.5 Loading printer paper (if printer is installed)
Operation procedures for loading printer paper:
1. To open the printer cover, press two thumbs firmly on both "OPEN" notches.
2. Move the tab of the left rubber roller lock 90°upwards to unlock it, refer to the following figure
with mark ①.
3. Cut one end of the paper into a triangle, and load the paper from the underside of the rubber roller.
4. Turn the roller clockwise to roll the paper rolled, and put the paper roll into the compartment.
5. Pull the paper out of the paper slot on the shield.
6. Move the tab of the rubber roller lock 90° downwards to lock it.
7. Put the shield back in position and secure it.
Operation procedures for taking out printer paper roll:
Steps 1~2: Same as above.
Steps 3. Roll the loading roller anti-clockwise and pull the paper out.
Steps 4~5: As steps 6~7 above.
17