Viking MI 632.1 Manuel D'utilisation page 166

Message:
2075 – GPS signal
No reception in desired zone
Possible cause:
– The desired zone is in a dead spot
Remedy:
– Redefine the desired zone (
Message:
2076 – GPS signal
Desired zone not found
Possible cause:
– The desired zone could not be found
during edge following
Remedy:
– Redefine the desired zone. Make sure
that the desired zone and perimeter
wire overlap ( 10.)
Message:
2077 – Desired zone
Desired zone outside home area
Possible cause:
– The desired zone is outside the stored
home area
Remedy:
– Redefine the desired zone (
Message:
2080 – Mains
No GPRS reception
Possible cause:
– No GPRS connection possible, the
mowing area is in a dead spot
Remedy:
– Contact a VIKING specialist dealer for a
detailed diagnosis
164
Message:
2090 – Radio module
Contact your specialist dealer
Possible cause:
– Communication with the radio module
interrupted
10.) Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your VIKING specialist dealer if
the problem persists
Message:
2095 – Radio module
Contact your specialist dealer
Possible cause:
– Communication with the GPS antenna
interrupted
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your VIKING specialist dealer if
the problem persists
Message:
2100 – GPS protect.
Outside home area
10.)
Machine disabled
Possible cause:
– The robotic mower was removed from
the home area
Remedy:
– Return the robotic mower to the home
area and enter the PIN code (
Message:
2110 – GPS protect.
New location
New installation req.
Possible cause:
– The robotic mower was operated on a
different mowing area. The wire signal
of a second docking station is already
stored.
Remedy:
– Perform new installation (
Message:
2120 – Child lock
Child lock active
Possible cause:
– Impact sensor triggered several times
consecutively
– Robotic mower has been lifted during
travel
Remedy:
– No action required – if the impact
sensor is not triggered again, the
message automatically becomes
inactive within max. 1 minute
– Deactivate the child lock (
Message:
4001 – Internal fault
Outside temperature range
Possible cause:
– Temperature in battery or inside the
machine too low or too high
5.10) Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery (
11.14)
11.16)
6.4)
0478 131 9936 B - EN