Viking MI 632.1 Manuel D'utilisation page 142

The docking station (1) is installed in
mowing area A. Mowing area B is linked
to mowing area A by means of a
corridor (2). The perimeter wire (3) can be
continuously followed by the robotic
mower. In order to mow mowing area B,
starting points (4) must be defined.
( 11.15)
Individual mowing operations can then be
started at the starting points, depending on
the setting (starting frequency).
Start and end of the corridor:
140
The perimeter wire (1) must be routed in a
funnel shape as illustrated at the start and
end of the corridor (distances A and B on
the iRuler). This installation prevents the
robotic mower from accidentally driving
into the corridor during mowing.
A = 10 cm
B = 17 cm
The dimensions are very much
dependent on the environment and
the terrain. For corridors with a
funnel-shaped start or end, always
check whether the robotic mower
can pass through it.
The corridor template (2) supplied can
also alternatively be used for installing the
funnel-shaped entrance and exit areas.
Installing the corridor:
Wire clearance in corridors: 27 cm
(distance C on the iRuler).
This results in the following space
requirements:
– between high obstacles (> 2 cm – e.g.
walls):
108 cm,
– between paths/obstacles that can be
travelled on (≤ 2 cm – e.g. paths):
27 cm.
0478 131 9936 B - EN